SYS 01
Fatigue & Endurance Rig Control Software
Automated multi-axis cycling, continuous load profiling, and failure-point logging.
Software that runs your test machine, captures the data, and proves the result.
We develop the control and measurement software behind mechanical and electrical test machines, from PLC logic to operator screens. Every test follows a defined sequence, every reading is captured, and every result ends up in a report your quality team can rely on.
Desktop and PLC software that drives actuators, pneumatics, and motors through repeatable test cycles
Clear, simple screens for setup, test selection, live status, and results
Direct interfacing with PLCs, load cells, torque sensors, and LVDTs
High-speed data capture with live curves during every test
Configurable test sequences, limit checking, peak detection, and pass/fail decisions
Auto-generated test reports and certificates, with results stored for every run
Automated multi-axis cycling with continuous load profiling. Every cycle is logged, and the failure point is captured automatically.
Live torque-vs-angle curves with peak-hold detection. Results are sorted pass or fail against your set limits.
Sub-micron LVDT measurement of radial and axial play. Verifies critical assemblies against tight tolerances.
Pneumatic control with load-cell acquisition under calibrated compressive force. Records deflection and yield limits for every part tested.
Controlled slurry pressure, pump timing, and spray cycles. Tests seal resistance under harsh, real-world conditions.
Automates droplet dispensing, electrode voltage, and leakage current detection per IEC 60112. Test certificates are generated automatically.
Built for test machine builders, testing labs, and component makers who need repeatable, documented results from every test.
Automated multi-axis cycling, continuous load profiling, and failure-point logging.
Live torque-vs-angle curves with peak-hold detection and pass/fail sorting.
LVDT measurement of radial and axial play verifying critical mechanical assemblies.
Pneumatic actuator control with load-cell acquisition for deflection and yield limits.
Controlled slurry pressure, pump timing, and spray cycles for seal resistance testing.
Droplet dispensing, electrode voltage, and leakage current detection per IEC 60112.